The next step was creating the hardware. … Continue reading
Tag Archives: PCB
So, this is the backup of the epathy board site I made a while back. It is a bit glitchy because it is ported, and a fair amount of content is missing. I hope to get it fully recovered eventually. … Continue reading
I debated weather(sp) I should look up decora gang plate dimensions, or measure one of my inserts. In the end I decided to go with drawings, and drew up a rough 3D sketch. … Continue reading
LEDs make everything better, including RC Cars! Draft! Summary … Continue reading
The ESP8266-01 is a cheap (~$2) WiFi enabled multiprocessor with enough GPIO pins to control three FETs. There are a few tutorials on setting them up that I used, and they are listed at the bottom. I wanted to make … Continue reading