I designed a holder for my new headset*. I was expecting my first try to need changes, either tolerances or bad measurements by me, so I printed it in pink. But it turned out fine. (printed on ender, designed in FreeCAD)
Excuse my lack of focus stacking (using a phone camera)
It may seem a bit tall, but that is so that the usb charge cable doesn’t undergo strain.
I wanted something that fit/lined up with the headphone, as well as holding the mic when I just wanted to use the built in one. Despite the number of soft parts it actually turned out well on the first try.
Mic slot detail
Simi-transparent detail